If not, the scanner can be dismantled to perform the inspection from one side of the weld.Ĥ. Yes, if the straight portion on each side of the weld is long enough, it is possible to carry out the inspection using two probes. Can the COBRA scanner inspect pipe-to-component welds?
They contain features such as scan speed, encoder capability, instrument linearity, software options, and data recording that make up the equipment portion of the overall process.ĬOBRA helps you achieve inspection compliance for:ģ.
Is the COBRA scanner AUT code compliant?Ī definite "yes "! Scanners and instruments are one part of an overall procedure or process, which has been written to comply with the various codes. Give a number that will work in every situation without being too conservative.Ģ. This combination can become a problem with very small and thin pipes. Small diameters lose a lot of power on each skip and thin wall pipe required multiple steps to cover wide welds. The customers need to make their own tests because we cannot guarantee the performance for their specific applications. It is too closely related to the defects, material type, noise in the material, and the operator's ability. We can't give an exact number for the wall thickness. What is the minimum wall thickness that can be inspected with the COBRA on the smallest diameter pipe size?
With its slim design, this manual scanner inspects pipes in limited access areas where minimal clearance is required. The COBRA scanner holds up to two PA probes for inspections on pipes with outside diameters ranging from 0.84 in. The COBRA ® manual scanner, combined with the OmniScan ® PA flaw detector, is used to perform circumferential weld inspections on small-diameter pipes.
Flaw Detectors / Phased Array Flaw Detectors ▾.Thickness and Flaw Inspection Solutions ▾.